MicroKOR



mailto:mail@microkor.biz?subject=MicroKOR Website visitor feedback
Main
About MicroKOR
Products
Old products
Русский




Seismological recorders

Magnetotelluric recorders

Controllers, special units
Digital recorders for audiomagnetotelluric researches
М-К2-SМ27 and М-К4-SМ27
TECHICAL REQUIREMENTS (ТU4314-027-46928948-2004)



Purpose
ТU4314-027-46928948-2004
PDF(PDF - 292 Kb)
The recorders as a part of the ACF-2.2 system ( М-К2-SМ27) or ACF-4M system (М-К4-SМ27)are intended for field electro prospecting investigations by methods of the audiomagnetotelluric soundings (AMTS), frequency soundings (FS) and for the electromagnetic monitoring.
The recorder is intended for transformation of received analog signals into digital codes of data acquisition (data collection), primary processing and storage in a digital form of information in non-volatile Flash-memory.
Channels of the recorder are connected with the two transformers of the induction low-frequency magnetic field (magnetic coil sensors or magnetic antennae) and two grounded electrical antennae via remote preamplifier.
Recorders have the metrological sertificate of quality.
Functioning

The recorder collects and stores data (along with service information, including coordinates, time etc) in digital form in Flash-memory.
The results of measurements are recorded in the file of *.sbf format. Each file contains records of time series of specified frequency ranges, the results of spectrogram calculations by processor of the recorder, the data of calibration, and additional information (time, coordinates, serial numbers of the antennae, comments of the operator, etc).
The main mode of the recorder is the mode of time series acquisition (collection). Mode of spectrograms measurements is parallel to the time series mode.
The recorder provides visual control of data directly at observation picket on the built-in display.
Software tools provide setting of parameters of data collection, allow producing of initial checking of the recorder functioning, exchange data with PC and to check results of data collection and their processing in digital and graphic forms.
In the free running mode the management of the recorder is carried out with the help of keypad, installed on the front panel of the recorder.
The management of the recorder can be carried out from the host PC with help of Ethernet. In field conditions portable PC (Notebook) can be used.
Power supply of the recorder is provided by an external or built-in accumulator.

Specification

Number of synchronous channels:

  • 2(for М-К2-SМ27)
  • 4(for М-К4-SМ27)


  • ADC data, bits: 24
    Range of input signals: not more, then 30 mV

    Operating frequency ranges :
  • 0,31 – 40 Hz,
  • 1,56 – 400 Hz,
  • 6,24 – 800 Hz(for М-К4-SМ27)


  • Sampling rates:
  • 160 Hz,
  • 1600 Hz,
  • 3200 Hz(for М-К4-СМ27)


  • Level of self-noise (RMS) within 10 – 800 Hz, brought to the input : not more, then 35nV/Hz1/2
    Notch filter 50 Hz
    The channel of data unloading: Ethernet 10 (UDP) 10 Mbytes/sec
    GPS support

    Frequency grid
  • discontinuity: not less than 10-5
  • stability (total by all factors) not less than 10-7


  • Volume of the built-in accumulator: 8 А*hours
    The voltage of power supply: 10,5…15 V
    Resource (in the built-in accumulator): not less, than 14 hours

    Dimensions: not more, then 400 х 230 х 180 mm
    Weight : not more, then 5kg



    Magnetotelluric recordersM-K4-SM27






    «Мастерская Евгения Смирнова»


    © Copyright 2007-2017 by MicroKOR Ltd. All rights reserved.