MicroKOR



mailto:mail@microkor.biz?subject=MicroKOR Website visitor feedback
Main
About MicroKOR
Products
Old products
Русский




Seismological recorders

Magnetotelluric recorders

Controllers, special units
Digital audio magneto telluric recorders
М-К2-SМ27, М-К4-SМ27



Purpose
M-K4-SM27
PDF(PDF - 6285 Kb)
Digital audio magneto telluric recorder М-К4-SМ27 as a part of the ACF-4m system is intended for field electro prospecting investigations by methods of the audiomagnetotelluric soundings (AMTS)for the electromagnetic monitoring.
The recorders are intended for transformation of received analog signals into digital codes of data acquisition (data collection), primary processing and storage in a digital form of information in non-volatile Flash-memory. Channels of the recorder are connected with the two transformers of the induction low-frequency magnetic field (magnetic coil sensors or magnetic antennae) and two grounded electrical antennae via remote preamplifier.
Functioning

The recorder collects and stores data (along with service information, including coordinates, time etc) in digital form in Flash-memory.
The results of measurements are recorded in the file of *.sbf format. Each file contains records of time series of specified frequency ranges, the results of spectrogram calculations by processor of the recorder, the data of calibration, and additional information (time, coordinates, serial numbers of the antennae, comments of the operator, etc).

The recorder provides visual control of data directly at observation picket on the built-in display.
Software tools provide setting of parameters of data collection, allow producing of initial checking of the recorder functioning, exchange data with PC and to check results of data collection and their processing in digital and graphic forms.

In the free running mode the management of the recorder is carried out with the help of keypad, installed on the front panel of the recorder.

The management of the recorder can be carried out from the host PC with help of Ethernet. In field conditions portable PC (Notebook) can be used.
Power supply of the recorder is provided by an external or built-in accumulator.

Specification

Number of channels: 4;
Work modes: time series acquisition (collection) / spectrograms measurements/ oscilloscope;
ADC data, bits: 24;
Built-in memory, Mbytes: not less than 500;

Range of input signals, mV: main - 30, supplementary - 6; 1000

General frequency range, Hz:

  • 0.1 – 40,
  • 1.56 – 400,
  • 6.24 – 800.


Sampling rate after decimation, Hz :
  • 160,
  • 1600,
  • 3200.


Level of self-noise (RMS) within 10 – 800 Hz, brought to the input, nV/Hz1/2: not more than 35;
Notch filter, Hz: 50;
General frequency range, Hz: 0,1 – 800;
The channel of data unloading Ethernet 10 (UDP) 10 Mbytes/sec;
GPS support;

Frequency grid:
  • discontinuity not less than 10-5;
  • stability (total by all factors) not less than 10-7


Volume of the built-in accumulator, A*hours: 8;
The voltage of power supply, V: 10.5..15
Dimensions, mm: not more than 340 x 295 x 152 (Peli)
Weight, kg: 5 ± 10%



ТU4314-027-46928948-2004Magnetotelluric recordersM-K4-SM25






«Мастерская Евгения Смирнова»


© Copyright 2007-2017 by MicroKOR Ltd. All rights reserved.